That helps immensely!!! Did you by chance source the locking collars on the net? Do you remember the diameter that you bought? I found out that the blower is Canadian made and is a mix of SAE and metric hardware. Sorry that you lost the PTO housing. Mine just scares the crap out of me when...
I used the mid PTO on my B3200 for both snowblower and snowplow. This is my issue: The middle driveshaft is supported by two bearings. (Below diagram #030) There is a measurement for the driveshaft location in the manual of 5 1/8" toward the rear. The driveshaft is kept in place by two set...
The shaft goes through the back, through the fan and into the gear box. The gear box is supported with a bracket from above and the ends of the auger connect to bearings that are bolted to the sides. Here is a pic and the reason why I have to do this. I had a tarp over a $7 worth of concrete...
During this last snow season, I accidentally ran over a tarp and it tore up a plastic seal that is on the impeller. I finally got the seal. In order to replace it, I need to take off the impeller. The only way to get the impeller off is to remove it from the box of the snow blower. So today...
I bought the Kubota spacer kit for my B3200 to allow for snow chain installation. I am going to install it myself, not because the dealer wanted too much to do it but because I don't have an easy way to get it there. I asked the parts clerk if the instructions are inside. I was told yes. I...