Recent content by norshud

The only belt problem I had was after the initial break in I smelled the belts burn on a very hard pull for a large piece of wood. I then tighten the spring tension eye and I have not had a problem again.

I have always understood you must run at the rated input RPMs of the generator and it takes 2 PTO(not engine) HP per 1 KW of electricity.

N80, The learning curve is steep, but worth it. My mill has 24 leveling feet and until I purchased a self leveling green laser the setup was difficult with string. Not as bad with a 12 inch square sitting on the bunk to read the laser line from side to side. I messed with the magnetic scales...

N80, As an owner of a WC88 and a HM130MAX stationary site setup with 23 feet of cutting capacity (2 extra bed section) you made a wise choice in Woodland Mills. I also have the blade Sharpener from them. The WC88 amazes me every time I use it. I also use a handheld V type sharpener to to pull...

I have had a Woodland Mills WC88 for a few years. One of the best purchases I have ever made. The machine continues to amaze me every time I use it. I was so impressed with the engineering of this machine that when I wanted a Sawmill I purchased a Woodland Mills HM130 MAXX Sawmill. I have...

I have a 2012 5055D with 55HP engine and 47HP PTO. I looked up the other day to see if they still offered the 5055D and they do not. They offer a 5055E in 2wd which would be the equivalent. It is rated at 57HP engine and 38HP PTO. I thought how could this PTO drop happen and then I thought...

The instructions and install of the PTO light kit have it on the "drivers side" left side of the ROPS. This interferes with filling the fuel tank up from a 5 gallon container. Has anyone moved it? Did you have to rewire it with longer wires? Thanks in advance.