Recent content by njschwartz

Thanks! I saw this video but it was not entirely clear how he got it all apart. I did mess with one of the spindles today and got all 4 snap rings off. 2 of them sit on the outer sides of each bearing right next to each other. Even with those off the center shaft does not come out so I assume...

I have an FM72 that honestly has been nothing but a pain of late. I had a spindle go bad last year and opted to replace them all as it is a bit older anyway and several of them were a bit sloppy. All was fine until recently when one of the new ones basically blew out on me not sure if that is a...

You are correct Bearsixty7, that is a banjo bolt not a plug and it leads to the rear. I guess my pic might not be that great. In my case it goes straight to, I think, the hydraulic block/valve or whatever that controls the 3point? In your case I think you have a valve in between that control...

Hi all! I have been browsing the forum for awhile and trying to learn. While I get the basics, I am still a little lost as to how to achieve what I am looking for. I have the LS MT240e tractor that currently does not have any rear hydraulic hookups so I would like to add my own. I have...