Recent content by newholly

So I picked up the kit and ran into a few snags. It will not mount where they say it will if you have a Woods backhoe(even if tell them you have one they say it will mount up per instructions,it doesnt) this is where they want you to mount it, on the rear roll bar mount bolt as you can see to...

In the picture is this the hardline that you removed to hook up your 3rd function valve?

I have a TC40A Gear drive with a 250tl, is the Rabbit/tortoise switch on the joystick non operational for gear tractors? is it only for HST transmissions? It doesnt appear to do anything and I was hoping to use this for a 3rd function switch for a grappler. Thanks

Thanks to halfback for helping me research and providing me with some guidance on the install. The dx40 kits are identical to the tc 40 kits however the case 1st remote is 300 cheaper than the NH kit and the 2nd is 100 cheaper. I ended up getting both sets for 960 by locating some kits in...

If anyone has a subframe for a Woods bh90x for a TC40a please let me know. Thanks

Looking for a Subframe for a woods BH90x for a NH TC40a. Shoot me an IM if you have one.