neilpaku's latest activity

Toyota are apparently making a small pickup (not sold in the US) whose only ECM is for the a/c and ignition but only for timing and...

I'm in Western NY and have had a Ford 6.0 since 2005 in that climate - lows of negative teens and highs over 100. I've never used...

Snezzy has it - I taught my wife and kids to back using the lawn tractor and its trailer. I pointed out a couple of basic facts, had...

That's a lot of work for a little machine - well done! And nobody ever went wrong putting in more sub-base : )

It would be unlikely, because at the current rate of development, I think most new vehicle buyers will want electric anyway. A few of us...

Were both wheels that locked up on the same axle? If so, it could be that, because the trailer was empty, when the brakes came on at...

One option would be to fit an autogreaser. There'd still be grease but you'd deal with it less often. Other than that, you "could"...

If the shaft is bent as well, then just get a whole new shaft. It'll deal with the universal joints and the missing/broken shield. All...

I've seen a lot written about the 6.0 but I suspect that someone posting about their negative experience tends to get an oversized...

Try both and decide what you like. I've seen both from lots of operators (me included) with experience all over the map, and they all...

I just hit 140,000 on my 2006 F350 6.0. A warranty turbo (due to a seal failure) at 10,000 and not one single issue since then...

Have you guys considered fitting a 7 tooth sprocket? It's like changing down a gear. Chain runs slower for the engine rpm but makes a...

That was my reaction too, having spent a lot of time on a skidder, in which it's usually not possible to see the cutting edge; just the...

THought a "skidder" was a logging machine (by definition) for dragging logs out of forrest.... Why would you need one for "ranch"...

Consult the operator's manual - it will give instructions. For all the tractors I've ever operated with PTOs (just about everything that...