Okay, I found some time to take the engine out of the frame to gain access to all the bolts securing the oil pan (the front transmission prevented me from accessing some of the bolts while the engine was in the frame). While suspending the engine in the air (with an engine hoist), I removed the...
I split the tractor last night and can't see anything wrong with the clutch setup. It only has 300 hours on it since new...the tractor hasn't had a lot of use! I'll dial indicate it before taking it apart to explore the plates...to see if there is anything wrong inside. I also plan to take the...
Rebuild update...
It has taken quite a while but I finally got my 1920 back together this past weekend. After spinning the starter for about 10 seconds, she fired right up and the engine sounded great! Unfortunately, I ran into three problems that are pretty disappointing:
1) after starting...
Took my 1993 Ford 1920 dash apart to troubleshoot some display issues. Found major mouse damage to the wiring. Anyone been through this before and came up with a good fix? Can I buy the wiring from the dealer or are there companies out there that can rewire the dash panel?
Thanks in advance,
MM...
Hello everyone!
My 1993 Ford 1920 SSS 4WD needs an engine rebuild. Mice ate through the oil pressure sensor wire and I wasn't alerted the engine was low on oil. While snowblowing earlier this month, the engine started chirping/squeeking/knocking and blowing oil/smoke out the valve cover vent...