Recent content by MMM2

I have a 60 in. Exmark. Whenever I turn it, it almost always gouges. The deck is so heavy, it does not lift. Especially when it comes to grass on sand base. My opinion: the wheels do nothing but dig, If you had a round shoe, like some snowplows do, the deck might skid over the ground rather then...

I also have a leak(significant), The problem is isolating it. I used the black light method, but when I viewed it, the leaked material was everywhere, more toward the Right side(yes, I did clean with solvent first). I cannot reach the fittings under the tractor(the area located below the seat...

There is no problem with the operation. Mechanically . If it does not reset by removing all electrical power from the unit, you could have a corruption/fault on the control board circuitry (I don't think they have replacements for that cheap part) If you knew someone into electronics, you could...

Hello, I have a car that is very low. I cut to 2 x 8 x 2' at 45 degree for both front tires. If you need more then stagger another couple. you are building a gradual incline. Think about it , not difficult and it is a lot cheaper for lumber you can keep for all oil changes.... Good Luck

Hello, I also have a hydraulic leak. If i can source the leak , I would attempt repair but, it is not coming from cylinders . When I start it I can see the fluid over all the under side on R side of 45 DA New Holland 2005 . Any suggestion on how to narrow my search. I sprayed with cleaner first...

Hello I have purchased many of these pick ups. If they are too heavy, it don't work. If took cheap don't last. 5 acre of lawn, I use cheap HF one, last one season if I don't run it over with 0 turn mower. very time consuming