Mike1955's latest activity

Mihindra I’ve never did that job. But taking it a step at a time you can do it. It’s kinda fun and keep you looking ahead. I just think...

The best way to keep oil off the floor is to wear a watch with one of those flexible metal bands. That way when oil runs down your hand...

All these are really impediments and annoying. But to meet the criteria for bad would be for something to go wrong on the oil pan side...

That model may have the regenerative dump option which speeds up the dump by 30 - 40%. Soft or spongy normally indicates that air is...

There is a grease zerk in there. Carefully turn the rotor shaft until it comes into view.

I never thought about that. I guess they kinda help with some end play. But I don’t really know if it would hurt to omit that. Someone...

Tide washing powders. Good as it gets. Scrub it with an old broom

You are asking a pretty complicated question. But here is a start... Look at your high pressure fuel pump - the one that runs the...

It's easy to tell if you have a suction air leak. Cold hydraulic fluid that has set overnight is clear. If you pull a sample of oil...

Thank you for your great instructions and although the pickup screen was clean, it did lead me to looking at the suction side instead of...

Oil trim I don’t think a relief valve would cause that effect. That machine definitely has a lot of wear in the cylinders and the...

Well you might be right. This was a single action cylinder I just replaced. I replaced it, was only 2 hundred something, instead of...

Another opinion, sounds like the cylinder leaking through. It is worse when warm. Just what I’ve run into on my stuff

I bought on for my woods bushog at tractor supply. Less than 300. Their people are absolutely useless helping with anything aside from...

The first thing you need to do is power wash that thing.;)