matthew.maxwell2's latest activity

That's exactly what I was going to try next because I was wondering the same thing

General update. Again, thanks for all the ideas and suggestions. What a great community to be a part of. I feel like the whole group is...

I think your graphics are good! I think I'm going to plumb them in parallel before I try ratchet jacks. We'll see.

The center cylinder seems to extend and retract the entire way. I will plumb them in parallel if I have to.

The wing cylinders are smaller diameter than the center cylinder, but appear to be the same size. The first two cylinders in series...

Found in the manual the rephrasing procedure. Your are correct it is extending, but doesn't seem to make a difference. I think it's...

Found in the manual that rephrasing is done by fully extending by up to a minute. Tries that and still no difference. Starting to wonder...

You are correct. I will make the exactly even before if do any mowing. I think I've pinpointed the bigger issue to phasing the lift...

Makes a ton of sense. I've been looking up rephrasing, and I have a few things to try. Thanks for the help, I'll let you know how it goes.

Not sure how much you can see from the pictures. The cylinders to list the wings are as simple as can be. One line from the tractor to...

Just picked it up at an auction, so I don't know much history on it. I did have to replace one of the gearboxes. I'll get some pictures...

I'll get some pictures when I hook it back up to the tractor this afternoon or tomorrow. Thanks for the help!

The deck lift cylinders are definitely double acting but the wing lift are plumbed up to be single acting. Looks like there are ports on...

I did even the ratchets back out. It's a JD 6415 and I believe it's an open center setup. It's seems like airlock on the lift...

After looking at it a little more, it appears the "phasing cylinders" for the wings aren't retracting all the way so they are different...