Recent content by marcuswayne

I think it was on a 16G Gravely tractor.

I just pick up a Gravely snowblower that go's on the front of there tractors. The S/N is 05117661 this is a 4" wide snowblower. I would like to put this on the front of my 4-wheel drive mini tractor. I will be putting on the blower it's on 20hp motor to run it. My question is how fast do the...

thank you

Can anyone tell me how many GPM a Sauer / Sundstrand hydrostatic drive series 15 pump is? It's a 15-2294 CW

oldnslo This is very interesting to read thank you. What happens now is if the front wheels have good traction the hydraulic pressure go's up and the pressure in the back wheel stay low because the back wheel motors are turning. The gear flow divider is working right just higher pressure on the...

How would I pair the frontend to the back of the tractor diagonally?

I have been looking at Pressure compensated flow dividers. Should I have used a pressure compensated flow divider instead of a rotary flow divider proportional divider. The rotary flow divider is what I am using now.

Out one side of the flow divider it supplies the two front wheel motors, out the other side of the flow divider it supplies the two back wheel motors.

This tractor I built about 8 years ago. I have a question about how to drive 4 hydraulic motors on my mini homemade 4 wheel drive articulated tractor. Each wheel has it own hydraulic motor on it and they are driven by a hydrostatic drive unit. I have a geared flow divider that supplies fluid to...

The speed that the saw cuts is manual. I have a hydraulic valve handle that I push down for the saw to begin cutting and after the log is cut I pull the valve handle up so that the 30" bar is out of the way. It works great, just sometimes you need to cut slower. I have ordered a inline metering...

I think that you are right. it will labor the hydraulic pump but I can adjust the pressure relief valve. Thanks

The problem with that is there are times when I would like to cut faster, like when I am cutting soft wood. When cutting hard wood I need to give the cutter bar more time to cut. The way thing are right now is it works great until I cut into something really hard and need to give the chain more...

Not sure of the flow rate, it also is hooked to other valves to run like the log hold down and the hydraulic motor to move the logs forward. So Im sure the feed rate is much higher.

The valve that I used is a small valve used on like a 20hp riding lawn mower.

I think that is going to be my next thing to try. The valve that I am using came off a riding lawn mower ( small valve ). The valve is open or closed. If I use a lager valve that might work, giving me more control over the flow. Thank you