Have you tried looking at Messicks? I looked around their site but I'm not finding it in the diagrams listed. Maybe you'll have better luck than I if you have not tried yet.
Tom...
The lift arms wont drop with me on them engine off, even trying to bounce a little they seem pretty resistant to dropping down any. Overnight, they will leak down with just the drawbar on it.
Thanks for replying.
tom
I agree, that flapper should open towards the carb venturi side and like the Jubilee, spring is missing. I've replaced that spring on the Jubilee and will fix the 2000 the same.
Finally, the left side. Anyway, my thinking is that with the lift functioning up and down as it should that the problem is not in the top plate but with the pump itself. It has to have prime since it moves...correct? I have not run the tractor with the side cover off to see if any leaks are...
As the title says, my dad's Jubilee's lift works up and down with the lever as it should, no shaking stopping or hesitations. However, I only have a draw bar and welded receiver hitch on the 3 pt and that's about all it can raise. If I hop on the the drawbar attachment, it can't lift my paltry...
Well, I have narrowed down the problem to the Marvel Schebler TSX428 bowl. I literally rebuilt the carb replacing one part at a time and trying on the tractor hoping to pin point the issue. Nothing helped with the only runs on choke issue until I got the idea of putting the carb from his super...
Got back to it and forced the choke plate out of the slit, slightly bent but flattened it back out. Installed the choke shaft return spring and temporarily put the choke plate on the shaft which I did from the air cleaner side. I'm hoping this is the correct way to do it. I have the carb kit...
Ok, one more video that shows choke plate being inserted from the air cleaner side which to me makes more sense as there just isn't enough space to insert plate from bowl side. I may have to ruin the choke plate on there now in order to get it out but I think I'll pay up for the premium Steiner...
This video was interesting in that the butterfly goes into the choke shaft slit just backwards of how the one on this jubilee is. I have to pulll the choke plat out towards the bowl where this one is going in from the air cleaner side.
Thanks for reply. No problem with seeing the slit and sliding the plate out but it gets to a point where it just wont go any further back as it's hitting the sides of carb and there's just a little more plate that has not cleared the slit if that makes sense. I tried turning shaft so plate is...
My dad picked up a Jubilee several years ago, drove from the auction and parked it in my yard. I've done a few things over the years to keep it running but it had a 3pt lift that functions up and down but will not lift my miniscule 230lbs. So it hasn't done anything and his health has been going...