Recent content by Lt340

  1. L

    Ehydro issue

    Thanks buddy. I haven't noticed the suction hose collapsing. I don't think it's a relief valve either because it would do it all the time. I was wondering about the pump too. Unfortunately I have found out the hard way that this tractor wasn't taking care of properly. When I purchased it the...
  2. L

    Ehydro issue

    No there is no noise. Just hesitation to move. I have found a sharp bend in the return hydraulic oil line from the cooler that obviously the previous owner bent. When at idle you can put your hand on the line and feel a slight resistance in the fluid pressure. I spoke with my mechanic friend...
  3. L

    Ehydro issue

    OK.... after weeks of checking this and doing that I have determined that my issue is lack of power due to the hydraulic oil getting hot. I have basically done everything I know to do to help the situation. I have made sure the oil cooler was clean and that it was pumping oil correctly without...
  4. L

    Ehydro issue

    I have the manual on my computer and a hard copy. I was leaning toward a relief valve too. I had to have the PTO valve cleaned and rebuilt because the previous owner obviously never used the PTO and the valve gummed up. It is highly possible it could be the relief valve because ever since my...
  5. L

    Ehydro issue

    Besides.... it does it no matter of load match is on our not...[emoji2369]
  6. L

    Ehydro issue

    The switch is on but the load match switch wouldn't cause this issue. It's like the hydrostatic transmission stops working completely. Works fine while mowing but as soon as you turn off the PTO there is absolutely no power to the pedals
  7. L

    Ehydro issue

    The pto is electric pull switch. There is nothing jammed up underneath. All the connections of the wiring to the pedals are connected and good. Once the tractor sets for a while it's all good. I'm thinking either electrical or a fluid transfer from the PTO valve.
  8. L

    Compact John Deere 4720 pto problems

    My 4320 had same issue. It turned out that the PTO valve was dirty and wouldn't allow enough oil to power the PTO. It also could just be the PTO selniod not allowing it to fully engage.
  9. L

    Ehydro issue

    My JD 4320 is having an issue with the ehydro. I was bush hogging this week and the tractor did great. When I was done and turned off the PTO and started to load the tractor on the trailer it wouldn't pull up on my ramps. I had to throttle wide open and it barely pulled up on the trailer. When I...
Top