Recent content by lt190b

On the front of the truck is a A frame tow bar built to bolt thru the bumper at the factory holes to mount the tow bar. It has a ring on the hitch to go on a pintle hitch. It was built just for these trucks.

This is the best pic I could find of the tilt front cab. It's the last of the international trucks and parts of my dads. If any one has interest or questions post response or PM me. Not trying to derail the question thread.

Does anyone know what the part # is for the Quick Hitch subframe for the boomer 54d? It fits the 72CBH front blade, broom and snow blower. Thanks

Just weld or bolt a ssqa plate to the back of your box blade.

What is the kind/brand or name of this connector? Its on a farmall 40. It is the one with 2 red wires, going to the fuse above the starter. Thanks

How is this?

Anti-stall, how does it work? What difference would/do you notice with it on vs it off? I posted in the New Holland forum and did not get any replies so I will try here. Maybe someone with anti stall on another brand could /would answer. lt190b

How does the anti-stall work? What difference would/do you notice with the switch off vs switch on?

How, and why to use this tab?

Sodo, thanks for your thoughts and artwork.The pictures you posted are the wheel side. The shaft is loose and probably never was tight The last 2 pictures are from the top,I hope these help?

This is it. (first picture) It is like the replacement one (#1) I have already put on. (second picture) is of the second failed one (#2) I am not real confident in this "new" fix. Time will tell. At least I have the original ones to hack up myself.

This is a caster yolk from my mower. Can you tell from the pictures if this is a welding failure or abuse?

Duerwood, is this motor, Char-Lynn 101-1750-009, what you would put on a cutter with an auxiliary standard flow of 20gpm and 3000psi on an excavator? Is the pressure from the ex too high?

Duerwood, what hydraulic motor would be a match for an auxiliary standard flow of 20gpm and 3000psi on an excavator and a ctl with 20.8gpm and 2600psi, maybe one motor for both? Here is the reason for my question.

I am working on a hook up of a hydraulic motor to an excavator. Aux pressure is 3000 psi the flow is 20 gpm. The motor is rated at 2000 psi continuous/2400 psi intermittently and 10 gpm. I have the flow control valve rated for this, my question is about the pressure relief valve. The valve is a...