Recent content by leslie428

Hi I just purchased a IH 434 1967 with loader and have replaced the hydraulics pump and am about to look at the wiring because I don't seem to charge the battery. Does anyone have a manual for a 1967 IH 434 with electrical drawings? I also need the drawings for the brakes, they are very...

PTO problems, can anyone help, Please!! Jinma 284LE 2005 vintage, Loader, backhoe, snowblower, chipper, cultivator, plow, log splitter, generator, mower, bush cutter, scraper/grader plow. Problem: PTO, once engaged, makes a horrible noise (high shrill) and when I press the clutch all the way, it...

I have a May 2005 Jinma 284LE with approx 70hrs on it. I have only used it for snow removal and grass cutting. Yesterday I was blowing snow and I noticed some oil on the ground. Upon further inspection I found it was coming out of the air vent of the hydraulic vent below the seat at the back...

I have now had my JM284LE for almost 9 months, worked like a charm through winter. At the same time I purchased an ATV 250cc ST. It came without a gas line filter and in fact the gasline was missing, but for the price that was OK, I purchaseed the stuff and installed and worked fine! HOWEVER now...

Could someone please take some pictures and show us exactly where we need to go to check fluids and where the plugs are that need to be removed to properly remove all the fluids. Reading some of the threads would indicate that some want-to-be tractor experts like me really are uncertain about...

china-ML-757102-ML- Moved to Chinese forum because it's brand specific.

To all those who have worked with a backhoe, please help. I have now ordered by backhoe hydraulic pump and will be shortly installing it on my JM 284 LE. I have read the manual, etc. but really what I am looking for is someone who has used this backhoe or others and can give me some tips so I...

In the picture you will see that a grease fitting broke off and I removed it and tried to replace it with a standard 1/4 inch model. I burnt up three titanium drills trying to bore a new hole so I could tap the unit for a new grease fitting. NO GO. This stuff just does not allow itself to be...

I am having a lot of problems with grease fittings (zerks). It seems that once I have the grease gun connector on it and the grease in it becomes impossible to take it off. This picture shows the grease gun with the nipple of the grease fitting torn out. I am at a loss. I thought all these...

Does anyone know if I need to empty fluids before I remove the back plate to install the Jinma PTO hydraulic pump? Thanks for your help.

Shipping error got me a belly mower instead of finishing mower so I had to convert. It was easy. Just turn the drive on the mower 180 degrees and now you have a pull mower (finishing mower) You will have to make two extention bars. See pictures. Works like a charm! I have a JM 284.