Recent content by Lazy

Is the lift pump the fuel pump?

Forgot to mention the tractor is a kubota bx2230

Engine seems like it is starving for fuel when going down hill even with full tank. Replaced fuel and air filters, no help? Any ideas?

I noticed the rod was scored so, i just purchased a new cylinder. With shipping it was just under $500.00. i had already purchased the seal kit. So, i now a seal kit should i ever need one. And now i know how to remove the old seal and install the new seal.

Thanks for the reply, I turned the nut several times enough i thought maybe i had stripped the threads. So, I purchased a book on the loader and this is what it says. NOTE: On the 7108 Bucket Cylinder it will be necessary to drill a hole as shown in the inset, Figure 19. The dimensions of...

How to remove rod from Bucket cylinder, 7108 loader on ford tractor 1920

Hi Everyone I am looking for the part number for the Backhoe bucket tooth, the parts manual I have just say's as needed? I might have to knock one of the remaining teeth off and take it to a tractor dealer and try to match it up with what they sell. The hoe is mounted on a ford model 1920...

Hi Anyone here interested in Solar Power for the home? We are getting into it for back up when the power goes off and also to help offset the cost of Electrical bills that seem to keep going up. Charlie.

Hi Anyone have a good way to get to the fiting to remove and replace the hose feeding hydraulic oil to the backhoe? I see no way to get to the fitting unless I remove the loader control valve. the engineer's have out done themself's again. Charlie.

I got on the tractor today and started it and let it warm up for a few minutes, pushed the clutch in and started to put in gear and heard the gears grind:mad: I can't get the clutch to release the engine from the transmission so I can put it into gear. Is this going to be a dealer fix, or is...

this must be a texas snake

Hi I could use some help understanding the hydraulic system on the Ferguson TO-30 tractor. We purchased a dealer shop manual and parts manual, but they don't help me much. If anyone has experience with the hydraulics and could help me it would be very much appreciated. Charlie

Hi I have a TO-30 tractor and need some information, we just bought a service manual and parts manual but it didn't help. On top of and in the upper right hand corrner there are two rods coming out of the top of the hydraulic cover plate, the back rod is spring loaded held in the up position by...

Hi We just purchased a TO 30 Ferguson Tractor and have thought about adding a tach/hour meter from northern tool Item # 160590. Has anyone installed one of these and if so how do you like it?

Hi I thought this would be interesting to have 1920's Centaur Tractor, If we were not in the process of building a new house I would buy it. Charlie.