Recent content by Larry_Sheehan

My daughter's dog decied that my seat bottom cushion was a toy! I can't find a part number for the seat bottom. Us this available without buying the whole seat? It's for a 3510 bought in 2006 (new sheetmetal)

I've had it for 3 years, and it just runs! Today after the long HOT summer, it was time to shred the front field. The beast started in the first 3 seconds of cranking, ran for 3 hours, sipped some fuel, and I enjoyed being able to work outside without worrying about bursting into flames. This...

I changed my fuel filter a few weeks ago, and once I had bled the system, my 3510 seemed to run OK. Yesterday, I was shredding (running engine at the setting for 540 PTO RPMs) and the tractor would bog down and stall. It would restart and idle OK, but stall again soon after resuming high prm...

Just finished up. I had 1 problem which was that the hydraulic filter I bought had the wrong diameter threads (1" vs 5/8 or 3/4" whichever). Returned it and got another filter with the exact same numbers, and it was OK. Got a bit concerned that the front axle took 2 qts less than the specs...

I got a small tear in the vinyl covering the seat of my 3510. Has anyone got a means of repairing this that'll look better than the old standby (duct tape)? Ideally it'll wear as well and be invisible. I'm sorta thinking that I'd try one of those sets you used to see an TV infomercials.

A horse chewed the right armrest on my 3510's seat. My dealer hasn't been able to find a part number for the armrest, and says I can only buy the whole seat assembly! Does anyone have a part number?

The plastic cover on my PTO drive shaft has cracked. The steel is fine, I'm just having trouble finding a reasonably proced replacement cover. Any hiints?

MY 3510 worked fine until today. Now with the PTO selector in AUTO and the Column switch ON with the clutch disengaged the dash indicator flashes, with the clutch engaged the dash indicator is on solid as expected, but the PTO isn't rotating. I checked the fuse, it's good. I can't find the...

I am confused...my dealer delivered the tractor with the check chains in the second of the 3 holes in the lift arms. There's a decal on the rear by the fuel tank that seems to indicate that that hole should be used for a rotary cutter (shredder), which implies that the check chains should be...