Well I had my first mow with the Caroni and it did great. My toplink was just barely long enough, so I had it pulled in a bit to make sure it didn't break. I picked up a longer toplink today, so my next mow should be even better.
This is the position of the mower fully extended out.
Here's...
Jack, I was definitely disappointed, but I can understand Caroni not wanting to pre-drill holes on all units when 95% of them will never see a shift kit.
I made some good headway last week.
Holes drilled.
Assembly finally mounted!
In my previous post I showed the huge washers to put...
I got a little bit more figured out today.
In order to mount the strike plate for the hydraulic cylinder, I had to do some grinding on one of the welds where the 3pt link arm attaches. After that, the bolt holes lined up and the M18 bolt fit in fine.
I finally realized that the spacer the...
Well I finally have time to start getting the side shift kit onto the TM1900. The "directions" (if you can call them that) are TERRIBLE. I am trying to document the process in case anyone else can benefit from it.
To fit the side shift kit you have to take all the standard hitch equipment...