Recent content by kpmcneil

1963 fordson super major 5000. When I lower an implement with 3ph there is a distinct and pronounced shudder as it descends. Not an issue when raising, but I can't seem to set a constant draft angle, implement will raise at times without moving control. What part of the hydraulic guts should I...

The tractor clutch works fine when cold. After warm up and several clutch depressions, it appears the clutch stops engaging. Tractor won't move, no drive to the wheels. I replaced the clutch, no difference. The PTO works fine, and symptoms appear in all three drive ranges. I suspect something in...

My MF 50A backhoe has an awful lot of play left and right in the boom. The 4 pins that anchors the boom to the barrel cylinder (on the bottom) appear worn, and I'd like to replace them. Does anyone know of a simple way of removing these 4 pins without disassembling the entire backhoe and...

I've got a new jinma 6" pto chipper. After running about 10 hours, I noticed blades hitting cutting plate. So I adjusted cutting plate back, and after running another 10 minutes, same thing happened. Almost looks like the flywheel is moving fore and aft, although I can feel no movement. Blades...