I have oil dripping out of the split pin plug for the clutch housing. How can oil get it in there. I did have it over filled a bit ago and it was pumping oil out from somewhere. I have run the tractor since but today I put a few hours bush cutting. When I came out after paying for my fuel I saw...
Hi folks. I'm looking for some possible solutions to a new problem on a new to me tractor.
I recently bought a 2011 kubota L5740 HSTC. The other day I had a woods 5' bush cutter on the tractor and was running down the road from my field to my home as I wanted to wash the bush cutter off after...
Hi folks. I'm looking for some possible solutions to a new problem on a new to me tractor.
I recently bought a 2011 Kubota L5740 HSTC. The other day I had a woods 5' bush cutter on the tractor and was running down the road from my field to my home as I wanted to wash the bush cutter off after...
Hi Folks. I'm looking for a little help here. I have a 2005 Kubota L5030 HSTC. The cab is leaking water from under the heater fan area in the front right of the cab roof. I tried to such out the drain line with a vacuum and that didn't work. So I tried compressed air and that didn't work either...
Hi folks. I have a leak inside the cab in the front right corner. I suspect that the drain for the AC is blocked. Can someone tell me where the hose comes out, and maybe a quick easy way to unblock it. I was hoping maybe some compressed air forced back up the hose.
Thanks in advance for all the...
Hi I am closing in on the 900 hour mark on my 2005 Kubota L5030 HSTC . Kubota recommends a valve clearance adjustment at this interval. I am wondering about this. If anything the valves would be a bit loose which it better than tight. If I take it in and the mechanic sets them too tight a valve...
Hi Folks I am have an issue getting a diverter valve to work on my LA853 FEL.
I have a Kubota L5030 HSTC and I am trying to install a diverter valve for the curl/dump circuit to operate a power angle blade left and right.
The guy who is hooking it up has been working hydraulics for 24 years. The...
Good morning. I have a 2005 L5030 HSTC and am installing a diverter valve for the 853 loader. I noticed in my fuse panel that I have 3 spare slots. Does anyone know where I would look for the other end of the wire? I would like to operate the new valve on a separate fuse but don't really know...