Recent content by Kiotikarl

Hi guys, i haven't been here in soooooooooo long, i can't rememeber ;), anyhow, anyone here have or know anything about Eastwood welder/plasma cutters? Just happened to notice this company, and have not a clue about their products. Currently looking for a new plasma cutter. I did have an...

So far i find it to be a good machine, only thing i have replaced si the ground clamp. What i like is that the mig gun is pretty long, compared to my miller and lincoln models. I used the spool gun a few times to repare ski-doo stater casings and broken mag wheels, i use 0.035 4043 wire for the...

Have one, great allaround machine, i got the spool gun and cart too.

I have the same machine, have half a 12lbs roll used up on mig. I find it to be a good all around machine. Have not tig welded with it, but mig, stick and welded aluminum with the spool gun. Runs 7014 good, 7018 fair, but dont even think about 6010/6011

I have an Everlast Power Plasma 60S, great machine without paying for bells and whistles, always works when i need it, very satisfied with the unit, would buy another one without hesitation.

Hi guys, Just a quick question, my uncle has a 1986 MF1010 tractor 6x2 tranny, and he asked me if i new where to check the oil, i said to look for the dipstick but he said there wasn't any. Septical that there isn't one, i went to see, and i couldn't see it either, Does anyone know where to...

Just Though i'd show you my new welding rig.

Hi everyone, wondering where to find performance parts for my MS461. I've been looking over the net, but i guess i'm not looking at the right places:laughing: I need an after market ignition coil that doesn't have the rev limiter in it. Thanks

Finally the wait is over:cool2:

Well it's time to shop for a new saw, having sold my 1 year old saw, it's time to buy something else. If been shopping around and the 2 models i'm looking at are the 372xpg and the MS 461 arctic. I like to have lots of power, and do use the saw in winter and snow. I'll be using a 18-20 inch...

This is what i did for baby dump trailer, 3.5 bore X 24 stroke, same size s my load trail 5 X 10 dump trailer. Cost of brand new cylindre 340$ + 20$ for 2 brackets and pins.

These are some trailers that i've made, just for the fun of it:D

I'm presently shopping around for a new mig and plasma cutter. I previously had a miller 211mvp and spectrum 375 plasma cutter. Wanting to upgrade, i sold both...but too fast as all i have left is my lincoln buzz-box, and i have a few trailers to build, as well as a dump box for my Duramax. I...

HI all:thumbsup: Well with the sun starting to show itself my dad and I have started to get tractor fever again:laughing: Anyways our current tractor is a CK30 gear TLB, and we are looking at a DK50SEC, but the dealer (Distribution Payeur in the eastern townships) told us about th RX6010 with...

I like to blow more than to plow, but plowing is way faster, unless there's 2+ feet of snow. Blowers rule:thumbsup: