The saga continues.
I repaired the snapped input shaft and during the test re-fit I was hoping to see some positive results be actuating the atm before fully re-assembling with gaskets and the pedal assembly.
I was NOT successful in that dream. Once the cover was re-installed I was unable...
Excellent info. Thank you so much!! I think I found a part of the problem. Poor installation of the snap ring on the output shaft. There was too much tolerance between the case and the ring, allowing it to rock back and forth.
Hey everyone!
So I have a DK45SE hst that has around 500hrs on it. Its mainly used for property light maintenance and lately gets heavy boxblade use on my 5ac property. I run it primarily in M-range and keep my RPMS around 1500-2k when not on the PTO. It gets grease every 10-12 hours or so and...