Recent content by kingreboog

  1. K

    Oil & Fuel  Grease fittings for MX5800

    Found a grease fitting not shown in owner’s manual. Located on rear mount on 4WD front axel. Unlike the front mount there’s no breather plug. Grease or no grease needed? Doesn’t except much grease. Thoughts?
  2. K

    4WD Rear axle mount grease

    While doing routine greasing on a MX5800 I noticed a grease fitting on the mount at the rear of the front axel. Didn’t see any reference in the owner manual. No vent plug on opposite side from Zerk like the front axel mount. Won’t accept but the smallest amount of grease. What’s going on here?
  3. K

    Kubota 72" QA HD ROUND BACK BUCKET

    Looking to purchase a Kubota MX5200HST. The standard FEL bucket is the 72" light materials version. There's an optional 72" HD round back bucket that's pre-drilled for optional bolt-on cutting edge. We have rocky conditions where the FEL will be put to the test. Is it likely I'll tear up the...
  4. K

    Tractor Sizing  MX5200HST or MX5800HST

    I recently test drove a new MX5200HST (PTO power = 44.2 HP). Liked it! It fits my needs quite nicely. However, the MX5800 has a higher PTO HP rating (50.2 HP) and I feel that this extra power would allow me more leeway in my future purchase of a rotary cutter. Our cedar (ashe juniper)...
  5. K

    Shopping for first tractor

    Hello fellow members! I've joined this forum in hopes of gaining some expert and experienced advise before taking the plunge and purchasing our first tractor. After 9 years of sweat labor on our 39 acres in the Texas Hill Country, my wife and I have come to realize how valuable a utility...
Top