Recent content by kfanta

I know they make 3pt spears...I actually have one. Problem is you can't stack the square bales one top of one another...so they end up taking up a lot of space

I changed them to JPEG :)

I looked into doing a crankshaft pump and honestly there is not a lot of room between the engine and the radiator. So unless I am not looking at the right place not sure how it would fit. For 2 cylinders I think I am looking at around $400 for the pair. My other thought was a PTO driven pump...

Ok so I took a caliper out there and measured again and for the outside of the main cylinder I got 2.926" for the rod I got 1.503". The FEL is a Miller St. Nazianz Wisconsin. Serial#: 5480 Model#: 102 I have been working to gradually get the galvanized fittings removed on the pressure side...

I am looking to update the main cylinders on my front end loader. The previous owner put on the Front End Loader and while it overall works great the lift speed is slow. I believe this is because the tractor diverts 1/2 the flow to the power steering which means I get about 4.5 - 5 gpm going...