Recent content by JorgePR

I can not tell you what you could buy but, perhaps by reading what I use may help with your endeavor I have 3 acres just outside city of San Antonio, TX northeast corner. Very rocky and wooded with mesquite, oak, cedar and various other trees. Topography fairly flat, I do have a lawn tractor (JD...

Hello, reading some of the replies, I believe that if you could have it your budget - keep the Ferris and for the tractor perhaps a CK3520 HST w/ the implements you need to replace your quad, also if within budget get the 3rd function to the front for grapple, and other front implements. Hope it...

Looking for pictures, videos or any good instruction on how to install a summit 3rd function for my Kubota B2620. The instructions it came with lacking good 'how to'. Any help will apprecaite very much. Jorge

Thanks

Kubota B2620HSD, Kioti CK3520

Nice setup hope you work/enjoy it for many years. Do you already have the top link installed, how it works, I have the sme setup minus the hydraulic in the 3pt. Also have you used the grapple? Enjoy

I am not an expert by no means, but have a open station and in Texas there are times when is just too much to "enjoy the outdoors" then I went to a cab setup and enjoying the outdoors just feels much better. Yes I cleaned up many of my trees so I can go with minimal concern for hitting low...

Thank you the basic information works. I have a CK3520Se

Thank you good information

sd455dan thanks for the reply I will keep the info in mind, I'll keep looking for something a bit more reliable for the money. Thanks

Hello All; This YINTATECH Skid Steer Quick Tach Conversion Adapter Bobtach Latch Box Weld On QTK, I am thinking of adding a quick attach to my tractor but don't know if this one is any good or reliable. Any information helps. Thanks

Hello all; I have a 1970s JD 2030 diesel use on a 10AC Pecan Orchard (Just south of San Antonio, TX). It has been starting without problems once weekly but the other day we had weather low about 35 for a couple of hours and now it will not start; cranks but no start. Fuel tank was full had...

Not sure if tis is the right Forum: But here it goes; I am in the midst of purchasing a 10 acre pecan orchard. The first question - the current owner has most of the equipment to work the orchard, a tree shaker, older JD 2030 (I believe is a 1970s), pecan picker, harvester, cracker, cleaner...

Hello everyone; I am following a suggestion for this post, I have a B2620 (2008) 4x4 HST and the other day after some light work I shut it down later came back would not start. I already changed the OPC controller for a new one, readjusted the forward/reverse switch and ensured the PTO was in...