Recent content by JohnnyDark

Anyone have any experience with pumping 15-40 motor oil thru a 12 volt fill rite diesel transfer pump? Thanks, Johnny

anyone know the working pressure difference, if there is one, on a 1/2 steel braided cloth covered hose vs. and hose of the same type except it has a green stripe woven in? the kind that you can use the reusable fittings on. thanks , johnny

can it be done?

got a couple of projects and was thinking this may be the way to go. any experience with this product? life span? thanks, johnny

noob when it comes to paint. plenty of experience with rattle cans.i am going to paint my transcraft flat. i have sandblasted all the rust, lol,and am currently glazing the cancer spots around the holes. any recommendations on paint type and sealers and clear coats and now this is where my eyes...

no hyd pressure as far as i can tell , no power steering loader won't work, 3 point hitch won't raise. i tried bleeding the air out , lots of white stuff, water and oil mix. any ideas what to do would be greatly appreciated. 535 tractor with a tarboro built loader. thanks, johnny

i am looking at mr heater propane heaters for my truck shop. any recommendations? i have 2 @ 100 lb tanks plus several 20 lb tanks. shop is 24 x 36 with 15 tall ceiling. looking at the forced air line or the convection. any thoughts would be greatly appreciated. thanks, johnny

what type cleaners does everyone use in their parts washers?i was using straight simple green, but was wondering if there are better options.

anyone out there put one of these up? prices? thanks, johnny

anyone used an underlayment fabric under gravel? i am going to be starting a parking area for my semi trailers. also anyone used soiltac? thanks, johnny

wanted to pick up a set of fuel filters for my 535. $25 apiece. anyone know a wix/fleetguard/napa/?/?/? cross reference number? thanks, johnny

anyone out there have a fill station on their farm, home?needing to fill 20 lb tanks and taking them into town will be too much inconvience. wondering how to affordably set it up? not wanting to cut on safety, just on the cost. this will only be used by me. thanks, johnny

thinking about buying one of these for the occasional use. anyone had any experience with them? thanks, johnny

got the cement poured for my equipment repair pad.14 x 28 . that sure will make it nice to get up out of the rocks and wet. i am now going to get started on closing in half of the adjoining lean to shelter as a place to keep all my vehicle related tools, welder, chop saw, that sorta thing. i...

just got a new pressure washer from northern tool and it really does a great job. i got the 5.5 hp honda with a 2.5gpm/2700 psi pump. i am really pleased with it