Recent content by John in BC

I have a Bobcat CT 225 tractor with a 7ft hoe. If I am ditching I am glad for the reach as it means less tractor moving. As for buckets I have a 9" and an 18". The land is all a mixture of sand and bowling balls, both 5 and 10 pin. I prefer to trench with the 18" because the 10 pin balls don't...

Hi Winston1 Did you have any success this time with your dash. This is such a common, varied and frustrating problem. I was a manufacturer of wiring harnesses for several decades and therefore know how many things can go wrong. These problems can occur from poorly crimped terminal connection...

Hi, The CT225 dash uses what looks like the smaller of the lamps you are showing. They seem to be molded into the plastic 1/4 turn plastic base. So my question is what is that dash from or where do I find that small size light please? John

I HAVE posted previously about how the dealer did a minor fileing job on a notch for a fix. HOWEVER - I have just discovered possibly why this happens. You will see posts about Bobcat ct225 and kioti having similar problems with parking brakes. The complaints vary from uneven breaking to pedals...

Just thinking, if your electrical cables are taped every so often to the pipe which is not uncommon so that it follows rather than twisting and bunching. And you can see the cable 10 feet down, then maybe the pipe is not far away! If that were true I might start thinking about how I could rig...

How do I remove the light switch knob and flasher lever? Or do I, maybe it comes off with the cowel and it unfastens from behind, but I doubt it. Any help before I break it appreciated.

Or one might get lucky though many have Not. I was lucky enough to be able to put some oil on the shaft where it penetrates the hole into the housing and with a lot of force got it to move ever so slightly more and more. Now I Squirt oil on the housing above the shift entry hole as part of my...

Shortly after birth my ct225 dash became intermittant some weeks it works others it doesn't. Approaching 1000 hours now.

Same known problem with 2 local machines. Solution that came from the dealer was simple - just take a file to the notch making it a little deeper and it does work fine for 8 years. 2 minute fix!