Recent content by JoeL4330

can any one provide the wiring diagram for the rocker switch-on-joystick to the solenoid body ?

There are water soluble cutting/cooling aids such as pictured, as well as solids and "eco" friendly aids ... Buy CE-16 AGS Metalworking Fluids & Coolants from UseEnco and, of course, if you like the smell of french fries, there's always lard or equivalent

Glad you got it out ...you might "mike" it to see if it was oversize. I liked the pipe washer idea so much I tried to illustrate it, attached

Here are some pix of my tailwheel:

After years of use and intimate encounters of the worst kind with branches, my work lights needed rehab. I note, as do all of you with FELs, that the tractor's OEM lights must be there for some purpose other than nighttime visibility. My requirements, this time around, are to have fore and aft...

had WRLong electric third function that was installed along w my grapple. it failed, and I found myself unable to raise/lower the bucket (except through some trickery) and none of my rear remotes worked (including my T&T, and it's not easy to disengage an implement if you can't adjust the top...

Size matters — Canopy on top of too-tall ROPS doesn’t fit into garage. That’s my problem and here’s my fix. I want to be able to pull my Kubota L4330 into my garage, especially in the winter. I don’t mind folding down the ROPS, but my TufTop is/was mounted on the ROPS, so it meant taking it off...

Bota L4330: joystick will no longer stay in float detent position...suggestions?