I have a john deere GT245 with a stuck release lever. The lever on the back to make manually is stuck in. Can't pull it out. Hate to use to much force and break something. Any ideas
Anything on my 3 point will not hold position. Can't even hold up light pine straw rake. I'm thinking internal seal leaking fluid. Anyone had this issue?
Bought a Lowes special John Deere LA175 200hrs for $100. Had busted electric clutch stop. Not a bad deal. My only issue is the amount of paint flaking off. Almost all metal is paint free. Should I leave it alone or try to repaint? Not sure if it's worth repainting.
In the midst of cutting and the electric clutch flew off. The bolt is broke in the output shaft. I tried drilling with reverse bit but no luck. The bolt must be strong. Any ideas? Almost to the point of removing motor and do it from a bench instead of under mower.
I purchased a 60" frame without the gearbox. Unfortunately the pilot hole is 4-3/4" and not the common 5-1/4". Hate to cut on the deck. Anyone know where I can find the correct gearbox? Should be about 40HP.
I have a Bobcat T300 with low pressure shut down (05-14) code. Replace filters, fluid and sensor.
While checking the belt, the tensioner stop was all the way back and tight. The manual states to loosen bolt and slide stop forward all the to the idler arm and tighten. Is this correct? I would...
I purchased a 4300 sync reverser and it had no throttle cable for foot pedal. I have purchased the cable and bracket. Looking for pictures to see the route and how and where the bracket attaches. It will be on the right side, just behind fuse panel. The manual was no help. Pictures would be...