Recent content by Jeepdude2010

  1. J

    Front axle Grease fittings no vents wont take grease

    :thumbsup: I will take a look at the thrust adjusting bolt when I get home from work. When I had removed the grease fitting front axle pivoted fine. Only when I gave it a couple pumps of grease did the front axle pivot seize till pressure was released. I'm still confused on why the front...
  2. J

    Front axle Grease fittings no vents wont take grease

    Here is the zerk fitting. Same as the rear with no ball end, but with check ball.
  3. J

    Front axle Grease fittings no vents wont take grease

    I have a 2011 new to me TYM T233 tractor. I bought it used with 99 hours on it. For a piece of mind I have changed all the fluids in the tractor. Greased all the zerk fittings on loader and tractor except 2. I have downloaded the service manual and operators manual. It states to grease the...
  4. J

    Oil & Fuel  New Member....New Owner T233 Hydraulic Oil question??

    hello everyone, I just purchased a 2011 T233 TYM tractor with just a tad over 101 hours on it. I'm wanting to do a Full service in particular Hydraulic oil. I have searched and found wix numbers for fuel, oil filter, hydro filter. But for the life of me I can't seem to find a good...
Top