Recent content by Jason977

A friend of mine bought a chipper that appears to be a Jinma/Clone and never took the time to set it up properly so I told him I'd get it working ,in exchange for using it, of course. I have the pulleys aligned, set screws tightened, and anvil set 0.025" from the blade at the closest point...

Due to my general disdain for dealers and their service departments, I'm afraid I may blow this out of proportion, so I figured I'd run it by y'all first. I brought home my 3520/ 300cx & 4n1 two weeks ago. The dealer had to install the loader, bucket, and 3rd SCV for the 4n1. First I was...

I'm about to place an order on a 3520, but I've got a few last minute questions: They don't have the tractor on their lot that I want, so they're going to have to order it. Say it'll take ~3wks. Does this mean it's coming from the factory (preferrable) or from someone else's lot? The...

I'll be purchasing a new JD soon (3x20, specifically), and I have some questions in use since it's so drastically different from what I'm used to driving. PTO: I've never used an electrically controlled PTO. Do they engage soft or hard? I believe someone suggested they engaged hard enough to...

I've got an HD Bush Hog type mower that I'd like to use to open up the cleared area around the house a little. I just want to take what I have and push back the brush line ~10' or so. I was wondering if anyone had put 3ph attachments on the rear of their mower (remove the wheel, of course) and...

I'm shopping for a new tractor because my ol' faithful Farmall Super C isn't up to the tasks at my new property. My main desires are more power, live pto, better hydraulics, and an FEL. The tractor I'm leaning towards the most is the Deere 3320, but I'm a little concerned that I'll be left...