IXLR8's latest activity

What is this adapter you are talking about and how does it install on my torque wrench?

I read that in the instructions, but I have no idea how to attach/use that little wrench with my torque wrench.

I used a torque wrench for all cutters except the 4 on the outside edge, can't get my torque wrench/socket in there.

I finally finished my BH work, removed the BH and installed the stump grinder. I had a heck of a job getting the PTO shaft onto the...

I put in a recirc pump on my system that I can turn on/off remotely so it doesn't run all the time, that helped a lot with the delay...

I have propane for tankless hot water, gas stove and backup heat for the heat pump. I am in the process of pulling the tankless water...

You guys should consider yourselves lucky. I have 2 sisters, one hasn't called me in 50 years the other is in poor health and I bought a...

I wish I had a plasma cutter and the steel to do something with it.

I have a 2013 DK40SE TLB and I have an 18' deck on my trailer and it just barely fits.

My Backhoe makes a good ballast, but it hangs out too far for some of the areas I need to get into. Plus I forget it is back there and I...

I have a 2013 DK40SEH and I am trying to figure out what the max 3 pt ballast weight should be before I build one. The manual I have...

I got mine from MTL Attachments. They were the least expensive of the style I wanted and it works great. I'm not sure if they have...

HD- Love your office views.

Successful flight!!

At least this scrub was due to weather, not a ship issue.