IndyIan's latest activity
-
IIndyIan replied to the thread How to fix mountain washout.In addition to keeping water from flowing down that particular spot, you might drop a couple trees to get some light for some...
-
IIndyIan reacted to JimR's post in the thread DK40 front bearing failure @ 1300 hours with
Good Post.
I built a cement ballast out of a heavy 55 gallon plastic drum for doing heavy lifting with my loader. It works great without... -
IIndyIan posted the thread DKSE DS 2007 to May 2011 Front Axle and Bearing upgrade part numbers and diagram in Kioti Owning/Operating.I found this service bulletin in my searching and I thought it would be better to have here for those of us with these tractors...
-
-
II meant to write this sooner but just got to it now. The left front bearing on my 2011 DK35 SE failed much as described in post #1 in...
-
ILimb the top to get the weight off. Cut that first branch going down to the ground, let the next two carry the weight. Get the tractor...
-
IIndyIan replied to the thread 2011 DK40SE Front wheel bearing failure.Yes, after reading a bit on here many years ago, I do now make a point to have something on the 3pth, but the rear blade is only 3-400...
-
IIndyIan reacted to grsthegreat's post in the thread 2011 DK40SE Front wheel bearing failure with Good Post.
The bearing that kioti sold me was a timkin bearing when mine failed, but i had lots more damage to mine. And it happened during Covid...
-
IIndyIan replied to the thread 2011 DK40SE Front wheel bearing failure.I could get away with just replacing the outer bearing with the same and the one seal which would be a $100 fix. But given how easy...
-
II just had my left front wheel outer bearing fail. Heard an odd screechy tearing sound, looked under the hood, and then the axle and...
-
-
IIndyIan replied to the thread What did I do wrong with my flag stone path install?.I guess you could try to improve the drainage around your path so the base isn't saturated with water when it freezes. How deep does...
-
IIndyIan replied to the thread FEL bucket not level (Horizontally).Sounds like your loader mount isn't installed level? I imagine there must be a bit of adjustment available. Maybe loosen the high side...
-
IIndyIan reacted to DK35vince's post in the thread KB2485 Backhoe for NX4510 open station tractor with Good Post.
I have an 8 1/2' backhoe (Rhino 85) on my DK 35, the tractor seems to have plenty of hydraulic flow for speed on the backhoe. If I run...
-
IIndyIan replied to the thread KB2485 Backhoe for NX4510 open station tractor.Using the tractor hydraulics I think they are bit slow compared to a good mini ex, but get off the tractor and use a shovel for a while...
-
IIndyIan reacted to John_Mc's post in the thread 1st time at my new property & 1st time ever brush-hogging - some lessons learned with Good Post.
I use a hydraulic top link all the time with my brush hog, and on uneven terrain. I find it very useful when I need to back up over some...
-
IIndyIan replied to the thread Affordable GARDEN tractor.A used sub compact 2wd kubota/ford/diesel tractor without a loader should be available well under $10k. Even 4wd ones too I guess if...
