Recent content by indhrasena.reddy

  1. indhrasena.reddy

    Problem in Tranny

    My tractor 5500 4WD is building pressure in the tranny and blowing oil out of the hi low shift lever.
  2. indhrasena.reddy

    Problem with Bushhog

    Hi All, I recently purchased a 2007 3325 Mahindra.I can:t get the brushhog to go all the way to ground level. The hydraulics travel up and down but stop about six inches from ground level.I used the hog late yesterday for about 10 minutes but when I went to lower the hog today it would not go...
  3. indhrasena.reddy

    About the Cement Mixer

    Hi, All i have a cement mixer i was wondering if my remote valve could work the single acting cylinder i have on the mixer, i have two ports on the back of my tractor i was wondering can i just use one to work the cylinder on the mixer?
  4. indhrasena.reddy

    MY PTO SHAFT IS SPINNING BUT BLADES ARE NOT MOVING

    Hi, MY PTO SHAFT IS SPINNING BUT BLADES ARE NOT MOVING, What could be the causes & remedies??
  5. indhrasena.reddy

    what type of filter you use in a 4530 tractor

    Hi, I want to know what type of filter you use in a 4530 tractor?
  6. indhrasena.reddy

    How to check the rear axle oil in my 7520

    Hi, How to check the rear axle oil in my 7520 tractor.
  7. indhrasena.reddy

    PTO does not engage

    I have a 4110 Tractor, i'm unable to engage PTO. The control switch is on manual and the PTO on/off switch lights up when I push it. The button and dash light comes On but does not engage. Can you please suggest me what should I do. Thanks for your help!!!
  8. indhrasena.reddy

    Backhoe  zerk fittings coming off...

    I've 2615 with 1710b backhoe one of grease fittings is coming off i just want to know how i can fix it, if posible can i have a diagram of it
  9. indhrasena.reddy

    Glow Plugs stay on longer than 3 secs

    Hi, i want to know that can i get glow plugs that stay on longer than 3 seconds? currently its staying only 3 sec in my 2015 tractor. What are the posible chances that can stay on with my existing glow plugs, & why its getting off quckly. please reply for this mail.. thank you for your inputs!!
Top