Recent content by Hawkesbury

Set it on fire and call the fire department they will take care of it LOL

I’m in eastern Ontario also and have a CX2510 cab a smith welding pull type snowblower and Maschio flail with hammers. This combo works well for me warm in the winter and A/C I the summer with no bugs. It is a little low on power but going slow gets the job done. The cab was the best decision...

I bought a Kioti CX2510 with a cab because it came with a/c and heat the a/c is nice when worn with the flail mower in 90 degree heat

Seems a little high bought a CX 2510 HST with a cab AC and heat with a loader for 37k tax in

I’m getting most of the lights just not the preheat when turned to the left and glow plug when in the on position. It’s snowing outside so I’m sure it’s cold enough.

Hi it appears to be the same as the printed version that I bought with my tractor but is not any good for me as I have a CX 2510 HST Cab and the manual doesn’t cover it at all

That That’s what I’m thinking I have the service manual but does not show the cab version only manual,HST, and Eu versions

its a new model factory cab with heat and A/C

The dealer does not have any Cab models to check with non cab models work both turning the switch to the left light up the left hand light turning to the right on position lights it up for about 8 second s It’s about 30 f outside Mine shows no lights but the plugs are working. Pulling the dash...

I have the manual and the wiring from the harness is not present on the small connector from the loom to the dash is supposed to have wiring for the preheat and the glow plug and neither ore there. Supplying power to the correct pins on the dash and the lights come on.

Hi new to this forum just bought a CX 2510 HST cab and am having a problem. When i start the tractor I have no glow plug indication although I have checked and the timer circuit and glow plugs are working. Had the dealer check it and he found the wiring to light up the dash is not there the...