Recent content by Gurney10

If the blade has an adjustment such that the top of the blade can’t be angled vertically further away from the bottom edge, or rolled over somewhat that will help greatly. I have operated a motor grader in the past and that method helps to keep the bottom edge from digging in too much. Used...

I recently bought a used TC35D hydrostatic and the electronic hi/lo shift is in the low side and would not shift to the high side. I had hoped it was just the switch but I replaced it and still have the same situation. I don't think it is in the relay because I switched some of them around and...

I have recently purchased a new 723. I have not had the opportunity to use it a lot yet, but I did use it some drilling in some rye and it was still warm weather and the AC does not seem to be as good as the one on a Montana 4940 that I previously owned. Talked with the dealer and he said he...

Can someone explain (in laymans terms) the basic difference between an open center and a closed center hydraulic system?

My B7800HST seems to bind when the 3pt is lifting. It will lift for a way and then you have to relieve the pressure on the control lever before it will continue to lift. It will lift whatever load you have on it but this condition exists. Does anyone else experience this? Is it a normal...

I have a B7800HST, 2003 model with approx. 400 hrs. The 3 pt. lift works fine, except that when you engage the lift lever, it will lift some then seems to bind, if you release the pressure on the lift lever it then will lift the rest of the way as soon as you engage the lift lever. Has anyone...

I recently purchased a 2003 model 4500 4WD with front end loader. Has 230 hours and did an oil and filter change. Following the instructions in the owners manual, I removed the crankcase breather cap to fill the crankcase with the new oil. Much to my surprise, it will only take a very small...