Recent content by gunny0628

This happened to me awhile ago on my 55. They had to take it in and reset it. A mouse chewed through one of several wires to the DPF. It had to be reset and the wires redone.

I’ve had this issue for some time and it just got lost with the repair folks. The bucket wasn’t level and the first time I took the entire FEL assembly off it was a disaster. The pin on the left side was wedged so tight I had to put a shim under the bucket on the opposite side to counter it...

Thanks Don that’s good info. Something else to inspect and to keep on hand.

Where is this lever???

Thanks for the info Don - pretty helpful.

What is even the point of your response? Not helpful in anyway.

new QD installed (both male and female) and everything seems functional for now. I'll update if there seems to be any other problems, but I'm guessing this was the culprit.

new QD installed (both male and female) and everything seems functional for now. I'll update if there seems to be any other problems, but I'm guessing this was the culprit.

I'm going to replace this QD and see if that is the problem. It worked temporarily and then the problem came back - so I'm going to try and at least eliminate the QD.

I spoke too soon - well, not fixed. i thought it was the QD and unfortunately i am back to square one. i am going to replace the QD on that side and see if that fixes it with a new one, instead of a tinkered one. Also, when I took the QD off there was a ton of bubbles coming up through the...

well, not fixed. i thought it was the QD and unfortunately i am back to square one. i am going to replace the QD on that side and see if that fixes it with a new one, instead of a tinkered one. Also, when I took the QD off there was a ton of bubbles coming up through the hose. Could that be...

I just removed both quick disconnects/connects and found one of them to be 'not as rigid'. I took it apart with a pair of snap ring pliers and cleaned them out and now it is working beautifully.

I just removed both quick disconnects/connects and found one of them to be 'not as rigid'. I took it apart with a pair of snap ring pliers and cleaned them out and now it is working beautifully.

I just hooked up my grapple after the winter (here in Florida) to move some debris. I haven't had it hooked up since before the tractor leak issue I posted some time ago (maybe 10 months ago) over in the RK Tractor section. Anyways, I hooked up the grapple as normal, and went to pick up a...

Hey Don The FEL seems to be working fine. And for the most part the grapple works as it should movement-wise. I can open and close it, tilt and go up and down. The problem is that the grapple won’t stay shut and won’t shut with any force if there is any debris like tree branches in it. Once I...