Recent content by Grizzysdad

Thank you so much. I wish that this forum had a way to make this a sticky. I've edited the title to make this info easier to find.

Thanks so much Eagle1. I'll definitely forward any manual I find to you.

I have rodent damage on the wires running to the DPF sensor, Of course the little pissants left me about an inch of stub where the wires go into the main part of the harness, just enough to splice to. I replaced the wires, and it runs but has codes flashing, which tells me that the wire repair...

I just went to use my X3135h yesterday and discovered that pack rats had chewed through the wires to the DPF sensor, so I can't start it. Of course the little pissants left me about an inch of stub where the wires go into the main part of the harness, just enough to splice to. I'll need to add...

The battery finally died on my tractor, and I need some advice on getting it out. There are two sensors (I think) that are in the way of picking the battery out of the tray. They are secured with red plastic tabs that are supposed to turn to release them. They're both fairly stiff and I'd like...

I have a '19 XG3135h that has a grapple mounted on it. What kind of auger can I mount on it?

I have developed a leak in my hydraulics. The fluid is dripping out of the end of the axle in a steady stream. I know there must be a gasket or seal there, I just don't know if there's a way to replace it without taking the rear wheels off, which I am unable to do by myself.

I just got the tractor in the title, and it's got a 7209 loader on it. I just replaced the 4 hoses coming off the control box as they were all leaking. I took care to change them one at a time and have added 5 gallons of utf so far, with no response from the loader and nothing on the dipstick...

I just got the tractor in the title, and it's got a 7209 loader on it. I just replaced the 4 hoses coming off the control box as they were all leaking. I took care to change them one at a time and have added 5 gallons of utf so far, with no response from the loader and nothing on the dipstick...