Gord Baker's latest activity
-
GGord Baker replied to the thread Not the clutch!.I don't know what is involved with a 'Clutch Kit' but it sounds like a bent or broken 'Clutch Fork' or a failed Pressure plate.
-
GSounds like something is going on that is preventing the linkage from the clutch pedal fully engaging the clutch fingers via the throw...
-
GGord Baker replied to the thread What did I do wrong with my flag stone path install?.I have found that when using 24"x24"x2" Patio slabs that a 3/4" or 1" sheet of Styrofoam keeps them even and I have never had a frost...
-
GGord Baker reacted to WranglerX's post in the thread Owning a small tractor is a blessing. with
Good Post.
May I suggest using jack stands or hydraulic cylinder blocks when working under mower, tractor hydraulics are nor fail safe and have... -
GGord Baker replied to the thread Uncle's JD 4230.Trailer it. Worry free. There will be lots to fix.
-
GGord Baker replied to the thread Equipment security cameras.After the first ocurrance and after Police investigated, Park somewhere else!
-
GGord Baker replied to the thread This has me stumped..Check Valve clearances.
-
GLift it with a chain and another tractor or jack it up while having valve in lift position ( or remove hyd line on cylinder) and secure...
-
GGord Baker replied to the thread Tips on loading dead tractor.Remove the bucket. Try cranking the engine while holding on the Lift Lever. You might also Try Jacking up the bucket while tying down...
-
GGord Baker replied to the thread PTO Shaft to Gearbox Bolts Keep Breaking!.Take note of clutch plate spacing and loosen off bolts. Be sure the clutch is not Stuck. Run the machine level, Front to rear and side...
-
GGord Baker replied to the thread Parallel or perpendicular blade orientation when mounting 3 blades to a mower deck?.New tires are usually marked with a coloured dot to indicate where they should be mounted in respect to the Valve Stem.
-
GGord Baker reacted to LittleBittyBigJohn's post in the thread Parallel or perpendicular blade orientation when mounting 3 blades to a mower deck? with Good Post.
It shouldn't make any difference at all. They will slip some as you mow, so wherever you put them to start, they will be in a different...
-
GGord Baker reacted to dieselscout80's post in the thread Parallel or perpendicular blade orientation when mounting 3 blades to a mower deck? with Good Post.
Since most decks are belt driven the blades likely won’t in the same position after a couple minutes.
-
GGord Baker reacted to AndrewInOz's post in the thread PTO Shaft to Gearbox Bolts Keep Breaking! with Good Post.
Firstly is it possible that the shaft is being asked to collapse to less than its min ? Consider odd situations : mower rear raising up...
-
GGord Baker replied to the thread PTO Shaft to Gearbox Bolts Keep Breaking!.It appears that the bolts are getting hammered on the shank? Gearbox lube full?