Gord Baker's latest activity
-
GGord Baker replied to the thread Brush Hog mods.Well Done
-
GGord Baker replied to the thread Brush Hog mods.Of course you know best. That is why you are doing it twice!!!
-
GGord Baker replied to the thread Brush Hog mods.It appears that you are cutting 4" too low, not allowing the cut debris to escape.
-
GGord Baker replied to the thread Rear Finish Mower How to narrow a three-point attachment arms.It looks like they are not installed properly. Unbolt them and switch them to the opposite side. Mount both on either inside or...
-
GGord Baker replied to the thread Putting a 2.75" hardened steel pipe on rear blade for plowing in soft conditions?.No blade attachment will cure 'roller coaster' terrain. Hire in a capable guy with a small dozer to plane off high areas.
-
GGord Baker replied to the thread Putting a 2.75" hardened steel pipe on rear blade for plowing in soft conditions?.
-
GGord Baker reacted to ruffdog's post in the thread Putting a 2.75" hardened steel pipe on rear blade for plowing in soft conditions? with
Good Post.
I made brackets to hold snowplow shoes for when the ground is soft. -
GGord Baker reacted to Shawn T. W.'s post in the thread Putting a 2.75" hardened steel pipe on rear blade for plowing in soft conditions? with Good Post.
Would it be possible to add gauge wheels to the back, so you could adjust the height?
-
GGord Baker reacted to CalG's post in the thread Putting a 2.75" hardened steel pipe on rear blade for plowing in soft conditions? with Good Post.
It's done all the time, but where does one get "hardened pipe"? Regular steel pipe would prove the concept. Weld on a few tabs for...
-
GGord Baker reacted to dodge man's post in the thread Wanting to "cut" a slot in the ground with Good Post.
It’s called a trencher. What is your exact use? How far do you have to go? Would one of those sidewalk edgers work? Some of those...
-
GGord Baker replied to the thread Removing the front spindle assembly on an 8N.If there is no mechanical obstruction like a hidden C clip, try an Air hammer.
-
GGord Baker replied to the thread Removing the front spindle assembly on an 8N.If it is that tight, put it back together.
-
GGord Baker replied to the thread Spray On / Rinse Off cleaner and degreaser..They used to make better stuff. Brake Cleaner is my go to and I don't over grease my spindles. I change the oil in my X320 JD and save...
-
GGord Baker reacted to bcp's post in the thread Spray On / Rinse Off cleaner and degreaser. with Good Post.
Maybe remove gunk with Gunk? https://gunk.com/product/gunk-original-engine-degreaser-eb1/ Bruce
-
GGord Baker replied to the thread PTO Shaft to Gearbox Bolts Keep Breaking!.sounds like the Bearings on the pinion shaft are gone