Recent content by Gnome

Power and function is all normal and good once warmed up. Gonna check ejectors when I get a chance in a couple weeks.

My mt125 seems to be perpetually at the full mark, then suddenly will drop to quarter tank... and in nothing flat be approaching suck. Strange fuel gauge.... gotta keep an eye on it.

Figured out how to upload video to this forum. Started my LS mid day yesterday, temperature about 48˙, elevation 3,000', 20 seconds on the glow plugs. This tractor never started this rough with so much smoke when at sea level at similar temperatures. But, it does smooth out. Just rougher than a...

Thank you for all the responses. Yesterday, after fluids and filter checks and a lube job I fired up the little beast. Temperature was 38˙, but with snow flurries happening I suspect colder. With 15 seconds on the glow plugs and a slightly elevated throttle ignition was immediate, as always, but...

Filters changed at 48 engine hours in Oregon. Problem started immediately upon arrival in Idaho. Temps in June at start up were in 50˙ range, yesterday 28˙....

This past summer I transported my 2019 LS MT125 from sea level in Oregon to my Idaho mountain property at 3,200' elevation. Immediately cold start ups were rough and smokey. After a bit of warm up it smoothes out and all is good. Now that cooler weather is here the start ups have been noticeably...

After I was done excavating I returned the SCUT to Oregon and came back to my Idaho house last week for the pour. My concrete finishers had all set up and we had trucks in on Saturday for a successful pour. I'll let it set up for a few weeks and bring the tractor back over to re-contour the...

Took my LS M125 on a 550 mile ride from the Oregon Coast to the Idaho panhandle Memorial weekend to prep the floor of a 24' X 24' attached garage for concrete. Scratched up and removed about 6 inches crushed rock (11 yards) and excavated the front for an apron/walk/trench drain. Did the pour...

Howdy... New guy here. Just bought a new LS MT125 from a local dealer a few weeks ago and have been putting it through it's paces. I have noticed the bucket will bleed off and droop constantly, machine running or not, loaded or not. No hydraulic fluid showing anywhere, cylinders are as they...