Recent content by GJDUK

  1. G

    Hi from Scotland / Iseki TX2140F / Bolens G154

    Thank you. Hah. That's good to know. Thanks. Rgds, George
  2. G

    Hi from Scotland / Iseki TX2140F / Bolens G154

    Well ... I can understand you. That's all that matters. Thank you for the PDF. Very useful. Best Regards, George
  3. G

    Hi from Scotland / Iseki TX2140F / Bolens G154

    Thanks Catherine. I'll keep that in reserve. I'm making some progress on another thread. Rgds, George
  4. G

    TX 2160F, with front loader and backhoe, long term project

    Hi Chris, I think my loader is the same as yours. L20? Doh! Today I fully shut the 3PL lowering rate valve on top of the hydraulic block. This locked the transport box wherever it was and I could put the position lever fully down. Loader seemed better. PM sent. Many thanks again. Rgds, George
  5. G

    Hi from Scotland / Iseki TX2140F / Bolens G154

    Hi, I'm George from UK. I've been lurking here for nearly 3 years it seems. Probably about the same amount of time I've owned this tractor. I've finally started to take a bit more care of my tractor rather than just abusing it. It's a great machine. Any tips relating to manuals, procedures...
  6. G

    TX 2160F, with front loader and backhoe, long term project

    Thanks Chris. Those diagrams are very helpful. I use my 2140 very regularly because of the loader. The most I've lifted is about 200kg/440lbs. I'm amazed these little tractors can cope with a loader and rear weight (220kg/480lbs) never mind a back hoe. It wouldn't work on my patch ... 12 degree...
Top