Recent content by GisborneSouth

  1. G

    Change Bearings on K-Series EFCG Flail Mower Blade Axle

    Okay, the bearings are on. I have learnt to not use the grease nipple thread as the point holder for the bearing puller. I smoothed the starting thread and had to re-tap it. I suggest you use a nut or other spacer to keep the bearing puller point out of the grease nipple thread. No big deal...
  2. G

    Change Bearings on K-Series EFCG Flail Mower Blade Axle

    Hi Willy, that's the one. I have got to put the new bearings on Tuesday. I am waiting on the seals.
  3. G

    Change Bearings on K-Series EFCG Flail Mower Blade Axle

    Thanks for your advice. I have successfully removed the bearing race. I used the 2 holes in the race to use a drill punch and hammer to rotate the race. I cut 2 slots in the race where it protruded from the end of the blade axle. I then used a bearing pulley to get it off. Thanks for your...
  4. G

    Change Bearings on K-Series EFCG Flail Mower Blade Axle

    The mower is a KI-EFGC-125 Flail mower.
  5. G

    Change Bearings on K-Series EFCG Flail Mower Blade Axle

    Thanks for the tips - looks like a couple solutions there! I’ll give those a go.
  6. G

    Change Bearings on K-Series EFCG Flail Mower Blade Axle

    More photos for context
  7. G

    Change Bearings on K-Series EFCG Flail Mower Blade Axle

    I blew a bearing on 155 K-Series flail mower. It looks the bearing collar (is that what it is called?) for the drive side bearing is stuck on the shaft but I don't know what I am looking at. The bearing was fragmented and I have got the replacement bearing. I have measured the bearing and...
  8. G

    Oil & Fuel  CK3710 HST Steering Fluid

    Greetings All from Gisborne Australia! I have a Kioti CK3710 HST. The right hand steering drain plug has vibrated loose and is lost in the paddock. What fluid and quantity do I need to put in? Thanks!
Top