gengine's latest activity

I would check the battery, most importantly the battery terminals being clean, move on to the ground connections. also make sure your...

Grab a propane or MAPP gas torch and give them a little heat. If they still won't budge, a bigger breaker bar/impact gun is necessary...

Looks like a simple job, just a messy, oily, dirty, uncomfortable, neck and ab testing job. Sorry, just installed a 10 speed Eaton into...

Mihindra I’ve never did that job. But taking it a step at a time you can do it. It’s kinda fun and keep you looking ahead. I just think...

I ran/worked on a TD10, but if memory serves, it was a Perkins engine with a Lucas Cav injection pump. The fuel return went from...

410J is a backhoe, and has functions tractors don't typically offer. We had one a while back, now we run a 710L. I remember having...

@gengine I have a 3020 and had this exact same thing happen to me. The cause was there was frozen water in the air cleaner / oil...

Are your new spindles or pulleys the greaseable type?

Can you more closely describe your squealing? I'm asking for a metal on metal, which can squeal but usually has a grinding tone to it...

Not too tough, run the tractor up some good ramps, pull the belt, pull the blade, then there should be 3-5 bolts that keep the spindle...

Why don't you provide something useful and helpful to this? I had to take the stump jumper and blades off of mine to remove the gearbox...

The nuts are RH, and screw onto a keyed shoulder bolt; so no concern about the bolt spinning in the stump-jumper. I enlarged the hole in...

The Allis in my description taught me a lesson on black oil. It is normal to have the black oil quickly due to combustion gasses and...

I think WinterDeere got the Wyoming from my location under my username. Take a look at that list of tractors...every single one listed...

The timer relay is only activated by the seat switch. If you hit a bump and your rump leaves the seat, it buys you a moment to get back...