I have a John Deere 3720 and I recently started having a substantial hydro leak which appears to be real close to being under the seat. I have a air ride seat and for the life of me cannot figure out how to remove it. Couple things I could use help on, 1st can anyone tell me how this thing is...
I have a 59" JD snow blower on my 3720 and it works perfect with one exception. I can adjust it to go up slow or fast but down is another story. It is full blast to the ground. Does anyone have any suggestions?
I just get one issue fixed and I run into another. I have a John Deere 3720 and just put my mid mount mower deck on. When I raise it up it immediately starts to lower on its own. It does not show this in troubleshooting in the manual so I am hoping someone can lend some advise as to what to look at.
If anyone could please help me out with a wiring schematic for a John Deere 3720. I have someone trying to help me with the wiring to the forward/reverse and am in desperate need for this help. I have been unable to move F/R for a week and this mechanic is trying to troubleshoot for me.:confused2:
I took my new last year but only has. 30 hours snowblower out last week and after 5 minutes the center cable pulley snapped right off the bolt that goes into the hydraulic rod. I see these pulleys slide back and forth on the rod and am trying to figure out why this may have happened. Last year...
Is there anyway to check a FE213475 sensor? I hate to have to purchase 2 of them if there is a way to check to see which is bad. Any help would be appreciated.
Does anyone know if a RE213475 sensor is available at any auto parts stores. I see it online but was hoping it would be available at perhaps a Napa or Autozone?
Was hoping someone out there knows if there is a front mount snowblower available other than the 59" that John deere sells. I was just quoted a rediculous price from a dealer yesterday and am looking for alternatives. I need a kit that will lift it as well. Thank you for your help!
Just got in from mowing all night and 5 minutes from finishing the mower deck quit going up and down. First time in 310 hours that this has happened. Any thoughts?
I have a 2011 JD3720 with a 2011 300CX Loader I was able to get a new 3/8" hose and the correct connector to the tractor itself. I am having the problem with the fitting at the loader. The following is a photo of the fitting I have an issue with.
I just broke a hose on my loader and before I pop for a 70.00 hose I am wondering if there is anyway to reuse an existing fitting? I have been everywhere except Deere looking and cannot find a hose sold with the type of fittings that is on the loader end of the hose.