Fields_mj's latest activity
-
FFields_mj reacted to joea99's post in the thread Problems with salvage tractor. Advice needed. with
Good Post.
Be aware the AI is Notorious for "Hallucinating", that is "making **** up", based upon nothing. Several Lawyers have been cited by... -
FFields_mj reacted to Merck's post in the thread Problems with salvage tractor. Advice needed. with Good Post.
Motor vehicles have to declare salvage on the titles. Tractors don't have such. I would consult with an attorney and see what they have...
-
FFields_mj replied to the thread Problems with salvage tractor. Advice needed..Agreed. Best bet is to ask a lawyer from PA. At the very least I would report it to the BBB. I'd also try to reach out to what ever...
-
FFields_mj reacted to Little Red Tractor's post in the thread Problems with salvage tractor. Advice needed. with Good Post.
This question is best asked of an attorney in the state of purchase. It might be worth the cost of a consultation. I would also check...
-
FFields_mj reacted to dodge man's post in the thread Problems with salvage tractor. Advice needed. with Good Post.
Maybe I’m reading the OP wrong. I get the idea he bought the tractor from a dealer that had bought it at an auction.
-
FFields_mj replied to the thread When is a Chain at End of Life.I heat with firewood and cut mostly Hickory with some occasional oak, locust, and white ash mixed in. I've found that I usually break a...
-
FFields_mj reacted to Little Red Tractor's post in the thread When is a Chain at End of Life with Good Post.
I guess I'm the odd man out on this thread, as I have my chains sharpened commercially. I did a lot of hand sharpening in my younger...
-
FFields_mj reacted to WinterDeere's post in the thread When is a Chain at End of Life with Good Post.
I also take my depth gauges (“rakers”) down below stock, but when you have a forum full of relative notices recommending 20” bars on...
-
FJust lower your rakers or drags whatever you want to call them. Depending where from. Just set them right as you file the cutter back...
-
FFields_mj replied to the thread Worst oil change ever.I hate dealing with used motor oil! I used to burn it for fuel in an old diesel engine, and I normally handled it in 55 gal drums. I'd...
-
FFields_mj reacted to part-time-Farmer-NC's post in the thread How much ballast for a 40hp machine (TC40DA) with Good Post.
When I built my ballast box (a metal 55 gallon barrel) I put 2 3" PVC Pipes capped on one end with glue and the other the caps (rain...
-
FFields_mj reacted to jonsstihl's post in the thread How much ballast for a 40hp machine (TC40DA) with Good Post.
any ballast on the rear is better than none, someone already mentioned it but your hydraulics are individually actuated, you can lift...
-
FI had the same type of problem on mine when I bought it. I found plastic shavings and "crap" in the fuel line fitting at the filter AND...
-
FAfter using compressed air to clear the line supplying fuel from the tank to the filter mine ran fine. However, this past winter I...
-
FI would lean towards a restriction of fuel exiting the tank. I think the old "compressed air into the supply hose" trick would be next...