ericm979's latest activity

We resisted getting one for 20 years. When we finally did we realized they're far more useful than we expected. As long as I have rural...

Measure the distance from the pin the loader arm pivots on (by the operator station) to the pins where the bucket or skid steer quick...

This looks useful: Foxtail control in pastures and hayground

Unfortunately I had to do that for the last few years due to lack of room. It's a big implement when its off the tractor. The rods look...

I’m hoping I can use the guillotine for my cuts… If it works it should help a lot. 2019 pulled a permit to remove a number of trees…...

I have a Stihl MS460 that I usually run a 24" bar on. I have used a 32" bar for large trees. I have a 36" for it but haven't used it. I...

The foxtail's worst where I mowed in June last year right before the fire district shut down mowing for the summer. The grass was still...

I've also got foxtail in some of the pastures that I want to get rid of.

So far not much of the Foxtail Barley has made it into the hay pastures, but there is quite a bit in various grazing pastures. That...

You can look at a parts list to see if the blade bolts are all the same part number or some are different. I would expect the blade...

Lately I have been in the full throttle camp, except when I need slower string speed around fences or other obstacles. I find that I get...

One of the guys on a Honda SxS forum I visit makes custom-fitted rubber sheets that go under the seats. It's sold under the name of...

Been a long time since I bought a welder, but I'd say buy an inverter mig welder. Be sure to buy good quality mig wire unless you want...

A couple of days after buying the baler, I discovered that my Ford 1715 just wasn't enough to do the mowing and raking, so I had to come...

Well, I do work around permitting every day, although not Building permits. It's mostly about, think of your shadiest drunken uncle, and...