When looking for place to install a temp gauge sender, I found this on the water pump housing. It looks like tap, but I did not remove the weird plastic cap, for worry I couldn't replace it any time soon and we are in the middle of mowing season.
Anyone added a water temp gage to their Iseki?
I want one for my 1610. Wondering what size the temp probe for the light is, so I cna replace with a gage probe.
Occassionally I have a need to use my TS 1610 to move a few trailers around.
I really don't want to disconnect my finish mower, so I thought I might rig up a hitch ball on the front bumper some how.
Before I try to design something, anyone out there already come up with an easy way to do this?
Does anyone know if the key switch on the TS 1610 must be to the "on" that is to the right position, for the charging circuit to be energized? I mow only during daylight and don't want to run the lights.
On my 1610, the rear wheels can apparently be remounted to the rims to widen the rear wheel base by about 6 inches. I noticed sometims the rear lift arms rub the tire lugs when pulling the mower around corners. Is there any down side to widening the rear wheel base, more than the front?
Mowed for the first time with my 1610 pulling the Maschio 60" finish mower. The drive shaft keeps popping out of the PTO shaft. The top link is adusted as short as it will go, but the angle on this is very steep upward from the tractor to the mower connect point..
Anyone with a 1610 or 1910 can...
Hello all,
I am new to tractors and Iseki. Just bought a low time Iseki TS1610 that needed a radiator. Has pretty new Maschio mower on the back.
In the process of getting a few things taken care of. The tractor sat out under trees for years, so faded a bit, but running good other wise. Just put...