Recent content by eddieirvine

One chain saw i think is over looked unless more know about it than i do, This is a Husqvarna runs great and does what all the others do and does a great job at it the thing i do like is the primer bulb which others do not have makes for an easy starting saw in about 3 pulls not 10 like some...

Like the above post Amazon and TSC don.t buy anything at the store you listed

I have already posted no way i have a tandem axle trailer i just wanted to see the responses And figured it would end up like it did thanks for everyone that responded

This was before wire welding came out also and this could be done nicely with a wire welder also

you mentioned having a hard time brazing a hole one thing a lot do wrong is just heat the hole, you have to generate a lot of heat around a hole and test your brazing rod for even flow when that starts around your hole keep everything hot and push the rod in the hole it will fill nicely I was a...

ok this is why i asked i was aware of it not working but asking about it is good advice thanks for the reply's, I will stay with my tandem axle trailer

Not sure if i am posting on the correct title but i have a trailer i haul my Kubota L3940 HST on and i go by a uhaul place and we have all seen these trailers you drive up on and your front wheels sit in a formed dip your tires fit in and the back of your rear wheels are on the ground, Now is it...

If you can figure out what you need and what pulley you are going to use i can bore out the pulley or make bore one out to fit with a sleeve pressed in

I agree with deserteagle 71 i bought a used 1997 gmc flatbed dielsel good fuel mileage pull a house if you need to a great work truck 1/2 ton not enough wieght hauling

I bought a VTOMAN hand held jumpers you hold in your hand connect cables and jump vehicle or tractor works great Need to keep them charged up and ready to go and i do that inside where it is warmer, I had issues with my Gmc diesel truck 6.5 v8 and it started it without a problem in winter, found...

How many places make oil? It is made the same way not a secret formula, same on gas and desiel keep it changed with new filters !!

Any way you can get in touch with the company that is going to deliver your material with a lift gate, this would solve your problem.

Find someone to haul your tractor for you and pick you back up later that day or in a couple days with someone else to pick you up and take you home, So much easier I have a 1/2 ton pickup and it is not enough truck to do the job my tandem axle trailer handles it fine, so a 1997 gmc truck...

Husqvarna i have two 16 inch bar and 20 easy to start has primer bulb and have not had one issue with t doing what i want done, One thing i will add most saws will cut fine as long as you maintain your chain in sharp condition, keep at it don't need to remove a lot of material to keep a sharp...

looks great but you mentioned keeping the bucket lower? You must of forgot to do that ?