dustin3207's latest activity

sounds doable

I run a 700# Woodmaxx 62" flail mower on a BX2200. 22 Engine HP, and I think like 15.5 HP to the PTO. It runs it very well, and I've...

My L2501 easily turns a 60 inch flail, but like others have said, the grass you are mowing can make a difference. My setup can mow very...

Have a 52 flail with y blades on a 22 hp machine and never had a problem

Irun a 4.5 ft on 26 hp mahindra no problem running. Have to slow for tall or thick grass. Weight wise if I'm going uphill and lift...

Thanks for all the information! I decided to go with the Betstco EFGC125 with hydraulic offset. I decided on the 49” because I didn’t...

It sounds like you've already made up your mind. My 64" flail will load my 50hp on high weeds, so I generally use it as a finish mower...

Also depends on blade type or hammers and material being cut. Hammers take some power to keep spinning.

It really depends on what you will be cutting and the terrain. 60” is going to be more than what your tractor is going to want I would...

Go with the 48 unless you are only cutting light grass. I have an AGL165 which is 65in wide with 25hp at the pto and have to slow down a...

Your 25hp tractor has 19.3 pto hp. With the rule being 5 Hp per foot of cut, a 4 foot would be too much. Reality, depends on what you’re...

I have a Besto HD flail 7ft that has been performing well. My tractor is 52 hp. Sounds like 4ft would fit your tractor best.

If you have not made your mind up already I suggest that you buy the 36 inch cut model only. The 5 horsepower per foot recommendations...

Hammer blades is what I’d run.

The 60” is 720 lbs. The 48” is 600 lbs. My tractor is rated at 1800 lbs. at the pin, so no worries there.