dnw64's latest activity

I would also like to mention that when you start drilling with the PHD, don't let it feed itself. Make sure that it is pulling the loose...

I haven't dug deep there, but down 12-18" with a shovel is nothing. And lots of wells are just a piece of 2" pipe with a well point on...

I understand it may not be immediate, but yes, I have let the wheel spin more than half a turn, the pedal is touching the floor, and...

Ha, could be the obvious! Thanks for the kick in the behind. Will check it out...

...apparently. I.e. only one wheel spins when "engaged". Where do I look, or can I, to find out what the issue might be? B3030

I only have a 9 inch auger and I use it to plant all my trees and bushes. I drill about 3 feet deep and widen the top of the hole...

OK, after doing (an admittedly small) some research, I found this...

I will consider that. If I dril an extra 6" or so I could spade the hole square pretty quickly and let it fall into the bottom. Will...

Thanks much guys! I have read that the roots mostly want to go horizontal, so I will probably get the 18" and just drill as deep as the...

Good concept. Thanks!

These are really small, and in plastic pots. Waiting on confirmation as to what is available, but it looks like probably 2 gallon which...

Note too, that the center of the load will move AWAY from the tractor as you lower it. This will increase the potential of tipping...

Mine has ~1850lbs lift at the pins.. With forks, I could *barely* lift ~900lb pallets of shingles off the flatbed delivery truck, about...

If you have 2000 lbs at your pins you’re not even close to 2000 lbs 4 feet out. Counterweight is critical for safety but adds nothing...

I think a lot of the "best practice" will be a result of the use case. If you may or will be be using the engine (generator, chainsaw...